Silvercrest SFB 10.1 C3 Especificaciones descargar pdf (Pagina 100)

SilverCrest SFB 10.1 C3

98 - English

characters for a brand name. If you make a mistake, press to

delete the last character and enter it again.

7. Typically, different device manufacturers use different codes for their

remote controls. At this point you’ll have to find the optimum code.

The current code is shown under the selected brand name. You can

press the buttons to select the preset codes for the desired

brand.

8. Now test the code selected by pointing the remote control at the

device and checking if it responds properly to the button pressed . It

is not necessary to exit the setup mode to perform this test.

The following buttons cannot be used for the function test:

 , , ,

 the device buttons (4)

 the numeric keypad (11)

9. If most of the buttons work properly, press . The code is saved for

the device button selected .

10. If no buttons work properly or only a few do, press to select the

next code and repeat the test as described in step 8. Repeat this

procedure as many times as necessary until you have found suitable

code.

Press to go back one menu level. To return to the start window,

press one of the device buttons.

Repeat the above procedure for all devices you wish to control with your

new remote control.

Automatic code search (AUTO SRCH)

1. Press and hold the button for 3 seconds.

2. Press , select “CODE SETUP” and then press . Press

and select “AUTO SRCH”. Press .

3. Press the device button for the device you wish to program. Then

press . The remote control starts sending all available codes. This

is indicated by a flashing IR icon on the display.

By default the remote control sends the code for the button.

If no code is assigned to the button, the following codes will be

send for the different devices:

 TV:

the remote control sends the code “CH+”.

 DVD/CD/VCR:

the remote control sends the code “PLAY”.

 DSAT/CBL:

the remote control sends the code “CH+”.

 AMP:

the remote control sends the code “MUTE”.

 Other devices:

the remote control sends the code “CH+”.

4. If your device responds to the sent code by powering on or off or by

executing one of the above functions, press to stop the

search. At this point you are close to the correct code, but you may

not yet have found the one that matches completely, as the

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 113 114

Comentarios a estos manuales

Sin comentarios

Silvercrest SFB 10.1 C3 Especificaciones Pagina 100

Comentarios a estos manuales