Silvercrest SEM 1100 A2 Manual de usuario descargar pdf (Pagina 208)

DV-5100HD Introduction

English - 207

The status indicator of the charging cradle will light orange whilst

the battery is charging. When the charging process is completed,

the status indicator will light green. Now you can insert the

rechargeable battery into the camcorder. Depending on the charge

level, the charging cycle can take up to 2 hours.

If, after inserting the rechargeable battery, the

indicator remains green, this means the rechargeable

battery is already charged or it is not correctly

inserted. In this case, check the polarity.

Inserting the Battery

When the battery is fully charged, insert it into the camcorder as

below. To do this, open the battery compartment by gently pushing

on the marking and sliding it outwards (see figure 1).

Next insert the battery into the camera, as shown in figure 2. Close

the battery compartment by placing the cover on it and sliding it

inwards until it clicks into place (see figures 3 and 4).

You may optionally power the camcorder by using conventional

batteries. To do so use four AAA-sized batteries, 1.5V. Insert the

conventional batteries instead of the rechargeable battery into the

battery compartment. Always pay attention to the polarity. The

polarity is indicated with the symbols + and – on the batteries and

on the inside of the battery compartment cover.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 253 254

Sin comentarios

Silvercrest SEM 1100 A2 Manual de usuario Pagina 208