Silvercrest SL 65 T Manual de usuario descargar pdf (Pagina 34)

this satellite.

When you select a channel, the transponder, the satellite and the favourite list (if the channel is in the

favourite list) are marked with a different colour.

You can change all colours in the configuration menu.

In the lower left corner you will find an "Information" section, where you see the parameters of a

selected transponder or channel.

When you select a satellite in the satellite list only the transponders and channels that are in that

satellite are shown. When you click in a transponder or favourite list only the channels that are in this

list are shown.

You can adapt the design of SetEditSL65 to your personal wishes.

To change the size of the main window you can either click on the maximise button in the upper right

corner or drag one of the margins of the window.

If the main window is large enough, the channel lists can be shown in more than one column. Then

you have more channels in view. You can change the width of these columns in the configuration

menu on the tab sheet "General settings". In the section "Column width" you can enter if a new column

is created, when 100% (auto) or 90-30% of the channels are shown completely. The other channel

names are cut.

With "manual" you can enter the column width by hand. Select the function "Setup column width" from

the menu of the channel lists and then you can click on the position where you want to have the right

border of the first column.

Note: There is a minimum width for the columns. If the window is too small to show more than one

column the column width has no effect.

In the section "Cut names" you can enter if the channel name is cut at the end,

or if a part of the channel name is cut from the middle.

In the configuration on the tab sheet "General settings" you can change the menu language of SetEdit

(this concerns all opened SetEdit windows) and specify whether the PIDs are shown in decimal or

hexadecimal form (see chapter 8).

If you activate on the same tab sheet the option "Show channel count in lists" the number of channels

of each satellite, transponder and the FAV list is shown behind the name of this list.

Especially when you want to move channels from the beginning to the end of your list, it may be useful

to use the split function. With this function you can split your list into two parts, one showing the

beginning and the other showing the end of your settings (see chapter 3.b.)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 52 53

Sin comentarios

Silvercrest SL 65 T Manual de usuario Pagina 34