Silvercrest SL 65 T Manual de usuario descargar pdf (Pagina 37)

5.b Configuration

Click on the "Config." button to change the general settings of SetEdit. There are three tab sheets in

the configuration menu.

General settings

If you click on "General settings" you get the following menu:

In the field Comport you can select which comport of your PC is used to connect to your receiver.

The value Frequ. Tol. (Frequency tolerance) is used when importing and indicates the tolerance a

transponder frequency may have relative to the imported one to be considered to be the same. If you

have for example a transponder with the frequency 11721 MHz in you settings and you import a

channel with the frequency 11720 MHz and the frequency tolerance is set to 5 MHz no new

transponder is created. This tolerance is also used for the transponder list.

With Column width you can select if 100% (auto) or 90-30% of all channels have to fit completely to a

column. All other channel names are truncated. With "manual" you can enter the column width by

hand. Please select the function "Setup column width" from the menu of the channel lists and then you

can click on the position where you want to have the right border of the first column.

Note: There is a minimum width for the columns. If the window is too small to show more than one

column the column width has no effect.

In the field Cut names you can enter, if channel names that are too long (see column width), are cut at

the end or in the middle.

In the field PIDs you select how the PIDs are shown/entered (decimal or hexadecimal). You can also

switch between these two viewing modes, if you click on the "H" for hexadecimal or the "D" for decimal

in the frame of the "Information" section.

With Language you can select the menu language you would like. This language is taken for all

opened SetEdit windows.

With Always on top SetEditSL65 always stays on top of your desktop.

With Start with last used file SetEditSL65 opens automatically the last used file every time you start

the program.

With When loading use personal sat + menu settings you can, after you have once saved your

satellite configuration (the general settings are also saved, see chapter 3.i), use this configuration

automatically when loading settings. For example you can use your satellite and you general settings

always when you load settings from other sources.

If Restore last session when starting is activated, all editor windows that were opened when you

closed the last session are reopened (see chapter 5.a.)

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 52 53

Sin comentarios

Silvercrest SL 65 T Manual de usuario Pagina 37