Section 5
Removal and Installation
150
Step 5
Fit the cylinder covers in the same position from
which you previously removed them and secure
each one with two T40 Torx screws tightening
the screws to 13 lb-ft (17 N폷m).
앫
GO TO THE NEXT STEP.
Step 6
Assembly Check
The cylinder covers are numbered for sensor
installation position (refer to the arrows).
Install the sensors. Refer to the procedure in
this section.
앫
GO TO THE NEXT STEP.
Step 7
Install the selector cylinder.
앫
GO TO THE NEXT STEP.
Step 8
Re-check that the connector are tight and secure.
4007249a
CYLINDER
COVERS
T
4007252a
SENSORS
3
2
1
SELECTOR
CYLINDER
4007253a
Comentarios a estos manuales