Section 5
Removal and Installation
180
Step 1
Release Bearing
Removal
NOTE: YOU MUST REMOVE THE
TRANSMISSION FROM THE VEHICLE
TO REMOVE THE RELEASE BEARING
ASSEMBLY.
If the clutch actuator housing is removed: Slide
the release bearing off of the input shaft past
the release fork assembly.
앫
GO TO THE NEXT STEP.
Step 2
If the clutch actuator housing is not removed:
Remove the release fork assembly. Refer to
Release Fork, Standard and Roller Fork in this
section.
앫
GO TO THE NEXT STEP.
Step 3
Slide the release bearing off the input shaft.
Comentarios a estos manuales