Section 3
Maintenance
53
Section 3Maintenance
Release Fork Greasing Procedure (Standard and Roller Fork
Applications)
Step 1 For Standard Fork Applications only
NOTE: The ZF-FreedomLine does not require a
regular maintenance program. However, to
ensure maximum performance and quality,
ensuring that the release mechanism is
lubricated in regular intervals is beneficial.
In most cases, lubricating the parts twice per
year is sufficient. In some cases, however,
lubricating the parts quarterly is normal. Thus if
there is a bump noticed when going from
neutral into gear at standstill or when coming to
a stop, this is a signal that the lubrication is
required.
Using a 13 mm wrench, remove the clutch
inspection cover.
앫
GO TO THE NEXT STEP.
4002081a
4002081a
Step 2
WARNING
The vent plug will vent the vehicle’s air supply
down to approximately 75 psi. Wear eye
protection when completing this step.
Using a 17 mm wrench, remove the clutch
actuator vent plug.
앫
GO TO THE NEXT STEP.
4002086a
4002086a
Comentarios a estos manuales