Section 5
Removal and Installation
156
Step 1
Installation
Inspect the sensor and ensure the O-ring is
installed.
Install the sensor.
앫
GO TO THE NEXT STEP.
Step 2
Install the two T-10 Torx screws.
Tighten the screws to 3 lb-ft (4 N폷m).
Connect the sensor ribbon connector to the
circuit board.
앫
GO TO THE NEXT STEP.
Step 3
Install the four locking tabs.
앫
GO TO THE NEXT STEP.
4007245a
O-RING
4007243a
SENSOR
CONNECTOR
TORX
SCREWS
T
4007242a
Remove the locking tabs.
Comentarios a estos manuales