Section 5
Removal and Installation
127
Step 1
Input Shaft Seal
Removal
Remove the transmission: refer to Transmission
Removal in this section. The release fork and
bearing will need to be removed from the
transmission to perform this procedure.
Remove the four M8 hex-head screws and lift
off the release flange.
앫
GO TO THE NEXT STEP.
4007230
HEX-HEAD
SCREW
SEAL/
GASKET
RELEASE
FLANGE
SHAFT
SEALING
RING
Step 2
If necessary, remove the seal/gasket.
앫
GO TO THE NEXT STEP.
Step 3
Use a suitable tool to remove the shaft sealing
ring from the release flange.
Installation
Coat the sealing lip of the shaft seal with
grease. Press the seal firmly into the flange. The
sealing lip must point towards the
transmission’s interior. Install gasket/seal onto
release flange.
Step 1
Use four M8 hex-head screws to secure the
release flange. Tighten the screws to 17 lb-ft
(23.05 N폷m).
4007230a
HEX-HEAD
SCREW
SEAL/
GASKET
RELEASE
FLANGE
SHAFT
SEALING
RING
T
Comentarios a estos manuales