Section 5
Removal and Installation
151
Travel Sensors Engage,
Splitter, Range and Select
WARNING
This procedure is to be performed only with
out-of-warranty cases. During warranty period,
the complete TCU must be exchanged.
NOTE: The repair kit contains two screws, one
retaining plate, one travel sensor and one
O-ring.
Removal
Step 1
Clean the area around the sensors.
앫
GO TO THE NEXT STEP
Step 2 Carefully raise the tab and pull the connector off
the sensor contact.
앫
GO TO THE NEXT STEP.
Step 3
Remove the two screws and take off the
retaining plate. Pull out the travel sensor
complete with the O-ring.
앫
GO TO THE NEXT STEP.
Step 4
Inspect the parts and replace if necessary.
NOTE: The sensors for the flange, splitter, main
transmission and select cylinder are identical.
Installation
NOTE: Apply Uni-Silicon GLK 112 grease to the
sealing and sliding faces.
Step 1
Insert the O-ring on the travel sensor.
앫
GO TO THE NEXT STEP.
Step 2
Insert the travel sensor complete with the O-ring.
앫
GO TO THE NEXT STEP.
Step 3
Install and secure the retaining plate with two
screws. Tighten the screws to 5 lb-ft (6.78 N폷m).
앫
GO TO THE NEXT STEP.
Step 4
Plug the connector in to the sensor contacts.
4007256a
SCREWS
RETAINING
PLATE
TRAVEL
SENSOR
O-RING
4007257a
TRAVEL SENSORS
CONNECTORS
T
Comentarios a estos manuales