Silvercrest SKAS 1000 A16 Especificaciones Pagina 43

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 192
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 42
Section 2
Fault Code Diagnostics
34
72 48 Short circuit to positive at the output
stage to the low range solenoid (Y8)
When submitting a warranty claim under standard
warranty conditions, the complete TCU should be
replaced and the entire unit submitted with warranty
claim.
Out-of-warranty only and/or no warranty claim
submitted, replace lower part of TCU.
Contact OnTrac at 866-668-7221 and request a
ZF-FreedomLine transmission specialist.
73 49 Short circuit to positive at the output
stage to the high range solenoid (Y9)
When submitting a warranty claim under standard
warranty conditions, the complete TCU should be
replaced and the entire unit submitted with warranty
claim.
Out-of-warranty only and/or no warranty claim
submitted, replace lower part of TCU.
Contact OnTrac at 866-668-7221 and request a
ZF-FreedomLine transmission specialist.
74 4A Short circuit to positive at the output
stage to the main solenoid (Y1)
When submitting a warranty claim under standard
warranty conditions, the complete TCU should be
replaced and the entire unit submitted with warranty
claim.
Out-of-warranty only and/or no warranty claim
submitted, replace lower part of TCU.
Contact OnTrac at 866-668-7221 and request a
ZF-FreedomLine transmission specialist.
81 51 Short circuit to positive at the output
stage to the inertia brake solenoid (Y1)
When submitting a warranty claim under standard
warranty conditions, the complete TCU should be
replaced and the entire unit submitted with warranty
claim.
Out-of-warranty only and/or no warranty claim
submitted, replace lower part of TCU.
Contact OnTrac at 866-668-7221 and request a
ZF-FreedomLine transmission specialist.
82 52 Short circuit to positive at output stage
to small disengagement clutch valve
Measure the resistance between pin 9 and pin 16 of
clutch actuator connector
Nominal value should be 14-16 ohms
If resistance is < 14 ohms, exchange clutch actuator
If resistance is within spec, exchange upper part of TCU.
83 53 Short circuit to positive at output stage
to small engagement clutch valve
Measure the resistance between pin 7 and pin 16 of
clutch actuator connector
Nominal value should be 14-16 ohms
If resistance is < 14 ohms, exchange clutch actuator
If resistance is within spec, exchange upper part of TCU.
84 54 Short circuit to positive at output stage
to large disengagement clutch valve
Measure the resistance between pin 12 and pin 17 of
clutch actuator connector.
Nominal value should be 14-16 ohms.
If resistance is < 14 ohms, exchange clutch actuator.
If resistance is within spec, exchange upper part of TCU.
ISO Fault Code Diagnostics
NOTE: ISO display codes may not be available on vehicles built prior to January 2006.
ISO Fault
Identifier
ISO Display
Fault Codes
(J587 Display) Fault Description
Repair Instructions
NOTE: The following repair instructions pertain to
active faults only. For information and instructions
about inactive faults, please contact OnTrac at
866-668-7221 and request a transmission
specialist.
Vista de pagina 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 191 192

Comentarios a estos manuales

Sin comentarios